The blog of Xeno, a slightly mad scientist
Blood glucose monitors are used to measure the amount of glucose in blood, especially of patients with symptoms or a history of abnormally high or low blood glucose levels. Most commonly, they enable diabetic patients to administer appropriate insulin doses. The availability of home-use glucometers, as opposed to clinical-use equipment, has greatly improved the quality of life of such individuals. However, such monitors require a blood draw through finger pricks for each test, which causes pain and inconvenience. Each test also requires a new test-strip, contributing to the recurring cost of such a device.
> Optimum insulin dosage, however, requires frequent/continuous monitoring of blood glucose, and currently available glucometers do not address this requirement. Continuous monitors do exist, but they need to be implanted under the skin, causing trauma while being implanted, and they need to be replaced every week. An alternative exists in non-invasive blood glucose monitors. This article introduces an architecture that uses Near Infrared (NIR) spectroscopy to determine blood glucose levels based on transmittance spectroscopy on the ear lobe. Using various body parameters, such as tissue thickness, blood oxygen saturation, and a linear regression-analysis based calibration system, an accurate and real-time architecture is proposed. An example implementation using full analog, digital, and mixed signal capabilities of a programmable system-on-chip, the PSoC-5LP controller from Cypress, is given as well.
I’d really like a non-invasive device to show my blood sugar. What’s the hold up? Is the FDA stalling to protect the US junk food industry?